DPA d:dicate™ 4017B Shotgun Mic w/ Rycote Nano-shield (CB) Bundle

DPA d:dicate™ 4017B Shotgun Mic w/ Rycote Nano-shield (CB) Bundle
DPA d:dicate™ 4017B Shotgun Mic w/ Rycote Nano-shield (CB) BundleDPA d:dicate™ 4017B Shotgun Mic w/ Rycote Nano-shield (CB) BundleDPA d:dicate™ 4017B Shotgun Mic w/ Rycote Nano-shield (CB) Bundle
DPA d:dicate™ 4017B Shotgun Mic w/ Rycote Nano-shield (CB) BundleDPA d:dicate™ 4017B Shotgun Mic w/ Rycote Nano-shield (CB) Bundle

DPA d:dicate™ 4017B Shotgun Mic w/ Rycote Nano-shield (CB) Bundle

Bundle Includes:

  • DPA d:dicate™ 4017B Shotgun Microphone
  • Rycote Nano-Shield Kit (CB)

DPA 4017B Shotgun Microphone

Equipped with a highly directional supercardioid pickup pattern, obtained using a supercardioid design with an interference tube that provides excellent off-axis rejection, the DPA 4017B is a short and exceptionally lightweight shotgun microphone that truly measures up to DPA’s impressive reputation for accuracy, clarity, and musicality.

Designed for a broad range of applications, the phantom powered 4017B is ideal for use with camera systems, in fixed positions at sports facilities, for broadcast/ENG/film booming, and even studio recording environments.

  • Excellent RF Immunity
  • Lightweight
  • Uniform off-axis response
  • Highly directional

Tune out the surroundings

Extensive research and development has been undertaken to optimize the sound coming from the sides and behind the microphone. Minimizing the often very un-linear response of a shotgun microphone due to its side lobes is one of the key accomplishments of the 4017B. The condenser capsule uses a high voltage pre-polarized back plate, endowing the shotgun with high output as well as wide dynamics, extremely low noise and distortion specifications.

Small size, big performance

At just 210 mm (8.3 in) in length and 68 g (2.4 oz) in weight, the aluminum-bodied DPA 4017B is among the smallest and lightest boom microphones available. But that’s not to say that it’s small on performance. Fully immune to RF emission, the 4017B’s 19 mm (0.75 in) condenser cartridge is capable of handling peak SPLs of 152 dB before clipping.

Screwdriver-free filter access

The 4017B features two onboard filters that are activated via an ingenious switching ring design. With the simple twist of two sturdy rings, engineers can implement a high-frequency boost that adds a 4 dB shelf at 8 kHz and a first-order bass roll-off below 120 Hz to minimize handling and wind noise. A permanent third-order high-pass filter at 50 Hz effectively removes unwanted low frequency disturbance from handling and wind noise.


Rycote Nano-Shield Kit

The Nano-Shield is Rycote’s lightest, smallest and most advanced windshield kit yet. The Nano-Shield has been designed to provide excellent wind protection and acoustic transparency for capturing clean audio.

Features:

  • 30% lighter than existing Modular windshield kits
  • Smaller overall footprint compared to existing kits
  • Interchangeable magnetic basket halves for fast setups & mic swaps
  • Redesigned & patented Lyre mounts offer improved handling noise reduction
  • No tools needed to make adjustments or swap out Lyre mounts
  • Oval blimp design with non-parallel sides offers better wind protection with less internal resonance
  • Large hexagonal pockets provide better acoustic transparency and less high frequency loss
  • Slim design friction-braking swivel arm
  • Low profile XLR cable with built in RF filter and switchable 80Hz low-cut included
  • Ergonomic handle with built-in PCS quick release
  • Removable / interchangeable windshield socks
  • Reversible XLR holder (points out for wireless transmitters & points in for direct-to-cable connection)
  • See compatibility chart for Nano-Shield Kits sizes to use with various microphones

The entire kit incorporates many patented designs including improved Lyre shock mounts which are more compliant for lighter microphones and a mounting bar / swivel arm that requires no tools to make adjustments or replace Lyre mounts.

The Nano-Shield kits are also extremely versatile with interchangeable basket halves that allow you to change the size of the blimps by swapping out baskets without the need to buy an entire new kit.

Note: All kits come with a low profile 3-pin XLR cable. Other specialty cables for certain mics sold seperately

What's Included:

  • 2x Magnet lock windshield basket halves with grey wind socks
  • Windjammer® fur
  • “no tools needed” Mic mounting bar with pair of Nano-Shield Lyre® mounts
  • Extra pair of Nano-shield Lyre® mounts
  • PCS swivel arm with friction brake
  • Interchangeable 3/8” thread mount for swivel arm (for non-PCS usage on booms or stands)
  • PCS ergonomic handle
  • Low-profile XLR cable with built-in RF filter and switchable 80Hz low-cut
  • 360-adjustable and reversible XLR holder
  • Extra pair of black wind socks
  • Protective case

Specifications

DPA d:dicate™ 4017B Shotgun Microphone

Directional characteristics: Supercardioid, lobe-shaped
Principle of operation: Pressure gradient, with interference tube
Cartridge type: Pre-polarized condenser
Frequency range: 20 Hz - 20 kHz, permanent third order high pass filter at 50 Hz
Frequency range, ± 2 dB, at 60 cm: 70 Hz - 18 kHz with typ. 3 dB soft boost at 15 kHz
Sensitivity, nominal ± 2 dB at 1 kHz: 19 mV/Pa; -34.4 dB re. 1 V/Pa
Equivalent noise level, A-weighted: Typ. 13 dB(A) re. 20 µPa (max. 15 dB(A))
Equivalent noise level, ITU-R BS.468-4: Typ. 24 dB (max. 26 dB)
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 80 dB(A)
Total Harmonic Distortion (THD): < 1 % up to 133 dB SPL peak
Dynamic range: Typ. 119 dB
Max. SPL, peak before clipping: 138 dB
Filters: High boost: +4 dB at 8 kHz. Low cut: First order filter, below 120 Hz
Output impedance: < 150 ohm
Cable drive capability: 100 m (328 ft)
Output balance principle: Signal balanced
Common Mode Rejection Ratio (CMRR): > 40 dB
Power supply: 48 V Phantom power (± 4 V)
Current consumption: 4.5 mA
Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: signal - phase
Color: Matte black
Weight: 68 g (2.4 oz)
Microphone diameter: 19 mm (0.75 in)
Capsule diameter: 19 mm (0.75 in)
Microphone length: 212 mm (8.3 in)
Output voltage, RMS: > 1.8 V
Polarity: +V at Pin 2 for positive sound pressure
Temperature range: -40 °C to 45 °C (14 °F to 113 °F)
Relative Humidity (RH): Up to 90 %

Rycote Nano-Shield Kit (CB)

Basket Capsule Size 131mm

Delivery Services

At Pinknoise Systems we like to offer our customers a wide choice of delivery options for their orders, and our prices are affordable and competitive. We also use only the best, most reliable couriers and delivery services to get your equipment where it needs to be - quickly and securely. Please find an outline of our services, prices and timescales below.

Service Timescale Price
UK Mainland Royal Mail Small Parcel 2-4 Days £3.99
UK Offshore Royal Mail 2-4 Days £9.99
UK Standard Courier 2-4 Days £6.49
UK Express Courier Next Day £7.99
International Shipping From 1-10 Days (Full Details) From £15.00

Delivery Times

Delivery times are based on when the package(s) leaves our premises. Sometimes, due to stock restrictions or a non-completed order, delivery may take longer as there is a delay with couriers, which is unfortunately out of our hands. If your order is urgent, or details change, please do let us know.
For full details, fees, and time schedules, please see our Delivery Information page.

Returns & Refunds

New items: You can return goods you have ordered from us for any reason, at any time within 30 working days of receipt (14 to initiate the process), for a full refund or for an exchange for a different product from our range. Items must be packed suitably and insured for full loss in the event of a delivery problem. Pinknoise Systems will not be responsible for lost or damaged return goods. Lost or damaged goods may affect the level of refund you receive. For full details of our returns policy, please click here.

Be the first to Write a Review for this item!

£1,879.00 £2,088.00
Saving Of:  £209.00 (10%)
(£1,565.83 Exc. VAT)
+

Availability:  

3 in stock now  

3 in stock now

Delivery hours
UK ORDERS: Order soon for delivery on using our express service

Model:  PN-BNDL-NANO-4017B
Manufacturer:  DPA Microphones

DPA Microphones
Contact us for advice

Need advice? Give us a call

(+44) 01453
825 802

International Delivery

International delivery

We ship across Europe and around the world and have a multitude of shipping options available to our international customers during the checkout, including express delivery for urgent orders.

NEXT DAY DELIVERY

We have a next day shipping option available for the UK with our DPD courier service, which features delivery alerts, personal delivery preferences and driver tracking with the DPD mobile app.

FINANCE AVAILABLE

Spread the cost to maximise your capital. Just call our helpful sales team on 01453 825 802, from 9.00am - 5.00pm, to discuss these options and find out what's available to you.

We accept Klarna, PayPal, Maestro, Visa, Mastercard & American Express

DPA d:dicate™ 4017B Shotgun Mic w/ Rycote Nano-shield (CB) Bundle

£1,879.00
× Site Currency
£0.00