DPA d:dicate 4017B w/ BubbleBee The Spacer Bubble (M) Bundle

DPA d:dicate 4017B w/ BubbleBee The Spacer Bubble (M) Bundle
DPA d:dicate 4017B w/ BubbleBee The Spacer Bubble (M) BundleDPA d:dicate 4017B w/ BubbleBee The Spacer Bubble (M) BundleDPA d:dicate 4017B w/ BubbleBee The Spacer Bubble (M) Bundle

DPA d:dicate 4017B w/ BubbleBee The Spacer Bubble (M) Bundle

This bundle provides no only a great microphone but also a great wind solution. So you're prepared for indoor and outdoor recording.

Bundle Includes:


DPA 4017B Shotgun Microphone

Equipped with a highly directional supercardioid pickup pattern, obtained using a supercardioid design with an interference tube that provides excellent off-axis rejection, the DPA 4017B is a short and exceptionally lightweight shotgun microphone that truly measures up to DPA’s impressive reputation for accuracy, clarity, and musicality.

Designed for a broad range of applications, the phantom powered 4017B is ideal for use with camera systems, in fixed positions at sports facilities, for broadcast/ENG/film booming, and even studio recording environments.

  • Excellent RF Immunity
  • Lightweight
  • Uniform off-axis response
  • Highly directional

Tune out the surroundings

Extensive research and development has been undertaken to optimize the sound coming from the sides and behind the microphone. Minimizing the often very un-linear response of a shotgun microphone due to its side lobes is one of the key accomplishments of the 4017B. The condenser capsule uses a high voltage pre-polarized back plate, endowing the shotgun with high output as well as wide dynamics, extremely low noise and distortion specifications.

Small size, big performance

At just 210 mm (8.3 in) in length and 68 g (2.4 oz) in weight, the aluminum-bodied DPA 4017B is among the smallest and lightest boom microphones available. But that’s not to say that it’s small on performance. Fully immune to RF emission, the 4017B’s 19 mm (0.75 in) condenser cartridge is capable of handling peak SPLs of 152 dB before clipping.

Screwdriver-free filter access

The 4017B features two onboard filters that are activated via an ingenious switching ring design. With the simple twist of two sturdy rings, engineers can implement a high-frequency boost that adds a 4 dB shelf at 8 kHz and a first-order bass roll-off below 120 Hz to minimize handling and wind noise. A permanent third-order high-pass filter at 50 Hz effectively removes unwanted low frequency disturbance from handling and wind noise.


BubbleBee Industries The Spacer Bubble (M)

The Spacer Bubble gives you the right Balance between wind-protection and audio transparency in changing conditions

The Spacer Bubble, Black is a multi-piece adaptable windshield solution for shotgun microphones designed specifically for boom operators, camera folks, sound mixers and all sound recordists who experience changing conditions. The Spacer Bubble includes the Spacer Base, Long-Haired Fur Cover and a carry pouch. A Short-Haired fur cover is available separately if you need it here.

The Spacer Bubble is also available in green, blue and red.

Features:

  • Switch locations fast and always get the best audio transparency while blocking unwanted noise from vocal plosives, boom 'swoosh' and wind.
  • Specially designed rubber base for super easy and secure mounting.
  • Base windshield made from highly efficient mesh to allow your microphone to sound as naked as possible.
  • Slip-on fur made from Bubblebee Industries' best imitation fur (high density of hairs per cm2) which allows for optimal frequency transparency and effective wind protection.
  • Quick drying fur: if it gets wet simply place it in the aerated mesh bag and allow it to dry naturally.
  • Available in seven different sizes - to ensure you find a size that perfectly fits your favourite shotgun mic.
  • Save valuable time while getting best quality.
  • Practical mesh bag included for easy storage and fast mounting.
  • Designed in Denmark by sound lovers, for sound lovers.

The Spacer Bubble shotgun microphone windshield is constructed of a noise-free mesh base, with a coarse foam inside and our specially designed rubber mount at the bottom.

The combination of the foam and the mesh provides the perfect conditions for recording indoors. And if you suddenly have to act fast and go outside, simply slip-on the long-haired fur and experience the optimal transparency within seconds.

When your recordings are wrapped, you can always keep track of your Spacer Bubble by leaving on the base on your boom or camera mic and store the slip-on fur in the included practical mesh storage bag. That way you’ll always be ready!

The materials used in The Spacer Bubble have been carefully selected and tested to ensure you are able to stay protected from the wind, whilst retaining as much of your microphones original frequency response as possible. If you're working in light to medium winds, we also have The Short-Haired Spacer Cover (sold separately) to allow you to further strike a balance between wind protection and frequency transparency.

Specifications

DPA d:dicate 4017B

Directional characteristics: Supercardioid, lobe-shaped
Principle of operation: Pressure gradient, with interference tube
Cartridge type: Pre-polarized condenser
Frequency range: 20 Hz - 20 kHz, permanent third order high pass filter at 50 Hz
Frequency range, ± 2 dB, at 60 cm: 70 Hz - 18 kHz with typ. 3 dB soft boost at 15 kHz
Sensitivity, nominal ± 2 dB at 1 kHz: 19 mV/Pa; -34.4 dB re. 1 V/Pa
Equivalent noise level, A-weighted: Typ. 13 dB(A) re. 20 µPa (max. 15 dB(A))
Equivalent noise level, ITU-R BS.468-4: Typ. 24 dB (max. 26 dB)
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 80 dB(A)
Total Harmonic Distortion (THD): < 1 % up to 133 dB SPL peak
Dynamic range: Typ. 119 dB
Max. SPL, peak before clipping: 138 dB
Filters: High boost: +4 dB at 8 kHz. Low cut: First order filter, below 120 Hz
Output impedance: < 150 ohm
Cable drive capability: 100 m (328 ft)
Output balance principle: Signal balanced
Common Mode Rejection Ratio (CMRR): > 40 dB
Power supply: 48 V Phantom power (± 4 V)
Current consumption: 4.5 mA
Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: signal - phase
Color: Matte black
Weight: 68 g (2.4 oz)
Microphone diameter: 19 mm (0.75 in)
Capsule diameter: 19 mm (0.75 in)
Microphone length: 212 mm (8.3 in)
Output voltage, RMS: > 1.8 V
Polarity: +V at Pin 2 for positive sound pressure
Temperature range: -40 °C to 45 °C (14 °F to 113 °F)
Relative Humidity (RH): Up to 90 %

Delivery Services

At Pinknoise Systems we like to offer our customers a wide choice of delivery options for their orders, and our prices are affordable and competitive. We also use only the best, most reliable couriers and delivery services to get your equipment where it needs to be - quickly and securely. Please find an outline of our services, prices and timescales below.

Delivery Times

Delivery times are based on when the package(s) leaves our premises. Sometimes, due to stock restrictions or a non-completed order, delivery may take longer as there is a delay with couriers, which is unfortunately out of our hands. If your order is urgent, or details change, please do let us know.
For full details, fees, and time schedules, please see our Delivery Information page.

Returns & Refunds

New items: You can return goods you have ordered from us for any reason, at any time within 30 working days of receipt (14 to initiate the process), for a full refund or for an exchange for a different product from our range. Items must be packed suitably and insured for full loss in the event of a delivery problem. Pinknoise Systems will not be responsible for lost or damaged return goods. Lost or damaged goods may affect the level of refund you receive. For full details of our returns policy, please click here.

 
£1,550.00 £1,731.00
Saving Of:  £181.00 (10%)
(£1,291.67 Exc. VAT)
+

Availability:  

2 in stock now  

2 in stock now

Delivery hours
UK ORDERS: Order soon for delivery on using our express service

Model:  PN-BNDL-4017-SB-M
Manufacturer:  Sennheiser

Sennheiser
 
Contact us for advice

Need advice? Give us a call

(+44) 01453
825 802

International Delivery

International delivery

We ship across Europe and around the world and have a multitude of shipping options available to our international customers during the checkout, including express delivery for urgent orders.

NEXT DAY DELIVERY

We have a next day shipping option available for the UK with our DPD courier service, which features delivery alerts, personal delivery preferences and driver tracking with the DPD mobile app.

FINANCE AVAILABLE

Spread the cost to maximise your capital. Just call our helpful sales team on 01453 825 802, from 9.00am - 5.00pm, to discuss these options and find out what's available to you.

We accept Klarna, PayPal, Maestro, Visa, Mastercard & American Express

DPA d:dicate 4017B w/ BubbleBee The Spacer Bubble (M) Bundle

£1,550.00
× Site Currency
£0.00