Microphone Accessories

• Molded rubber cup fits over the end of your H1a, H2a, or H2a-XLR hydrophone
• Made from the same acoustically-transparent rubber used on the hydrophones
• Simply place the hydrophone inside a bed with water for maximum efficiency
• Set the flat surface of the cup on the media to which you want to listen

• The MMP-G Modular Active Cable is an ultra-transparent preamplifier
• It can be combined with any modular capsule in the d:dicate™ Recording Microphones Series
• The MMP-G is available in two variations, MMP-GR with the cable extending from the rear
• Or MMP-GS with the cable extending from the side.

• Replacement foam windshield for the CM3 and OM1 microphones
• To replace used windshield after some wear and tear or loss
• Fits both CM3 and OM1 with an internal diameter of approx 20mm

• Replacement Microphone Clip for the CM3 and OM1 Microphone
• To replace used Microphone Clips after wear and tear or loss
• Fits both CM3 and OM1 

• Allows "12T" Microphones to be run on mixers with 48V phantom power
• XLR Connections
• Bright nickel finish
• Aluminum chassis

• Eliminates hum by isolating the ground
• Bright nickel finish
• Aluminium construction
• XLR Connectors

• The PSC LMP attenuates the line level audio signal by 50dB
• Used to provide a mic level output
• Bright nickel finish
• Aluminium construction

• Provides high frequency cutoff to reduce high frequency noise
• Bright nickel finish
• Aluminium construction

• Reverses the phase of a balanced line
• Corrects "T" power phase problems
• Bright nickel finish
• Aluminium construction

The PSA1+ is a professional studio arm for mounting microphones to a desk or table, providing full 360 degree rotation and unrestricted mic placement.

• Helps hold the XLR connector from your cable
• Reduces likely hood of rattle from connector
• Compatible with a wide range of Rycote products
• XLR cable not included with Holder

• Mic Flag for broadcast and interviews
• Large area for logos
• Shatter proof
• Suitable for microphones between 19 to 38mm in diameter