Schoeps CMIT5U w/ Bubblebee Spacer Bubble (M) Bundle

Schoeps CMIT5U w/ Bubblebee Spacer Bubble (M) Bundle
Schoeps CMIT5U w/ Bubblebee Spacer Bubble (M) BundleSchoeps CMIT5U w/ Bubblebee Spacer Bubble (M) BundleSchoeps CMIT5U w/ Bubblebee Spacer Bubble (M) Bundle

Schoeps CMIT5U w/ Bubblebee Spacer Bubble (M) Bundle

This bundle provides no only a great microphone but also a great wind solution. So you're prepared for indoor and outdoor recording.

Bundle Includes:


Schoeps CMIT 5U Shotgun Microphone

The CMIT 5 is SCHOEPS' shotgun microphone which has set a new standard for shotgun microphones since its release. The CMIT 5's directionality increases smoothly with higher frequencies, which results in a very balanced sonic character. In addition to this, the microphone's sound level decreases softly yet steadily for off-axis sounds, allowing these to be recorded neutrally as well as reducing the effects of movement during boom operation. The CMIT 5 also has a much stronger directionality than one might expect from a microphone of its length. If required, the CMIT 5 can also be used for music recordings, for example opera recordings.

  • Unusually low coloration of off-axis sound
  • Suitable for music recording as well as dialogue
  • Rotationally symmetrical polar pattern
  • Even greater immunity to wind noise than a SCHOEPS supercardoid
  • Very lightweight, robust all-metal housing

The sound quality of the CMIT 5 remains consistent even if the microphone is rotated on its axis, since its directional pattern is the same in both the vertical and horizontal planes.

Three pushbutton-activated filters allow the microphone to adapt to the recording situation:

  • High-frequency emphasis (+ 5 dB at 10 kHz) enhances speech intelligibility, and compensates for high-frequency loss caused by windscreens.
  • A steep low-cut filter (18 dB/oct. below 80 Hz) suppresses wind and boom noise.
  • A gentle low-frequency rolloff (6 dB/oct. below 300 Hz) compensates for proximity effect.

Pairs of LEDs next to each pushbutton indicate the status of the filters. Even in darkness the user can read the settings and see that the microphone is operational. The settings are retained when the microphone is switched off.

The capsule and amplifier of the CMIT 5 U are built as a single unit, unlike microphones of the SCHOEPS ”Colette” series.


Bubblebee The Spacer Bubble Softie Windshield (M)

The Spacer Bubble gives you the right Balance between wind-protection and audio transparency in changing conditions

The Spacer Bubble, Black is a multi-piece adaptable windshield solution for shotgun microphones designed specifically for boom operators, camera folks, sound mixers and all sound recordists who experience changing conditions. The Spacer Bubble includes the Spacer Base, Long-Haired Fur Cover and a carry pouch. A Short-Haired fur cover is available separately if you need it here.

The Spacer Bubble is also available in green, blue and red.

Features:

  • Switch locations fast and always get the best audio transparency while blocking unwanted noise from vocal plosives, boom 'swoosh' and wind.
  • Specially designed rubber base for super easy and secure mounting.
  • Base windshield made from highly efficient mesh to allow your microphone to sound as naked as possible.
  • Slip-on fur made from Bubblebee Industries' best imitation fur (high density of hairs per cm2) which allows for optimal frequency transparency and effective wind protection.
  • Quick drying fur: if it gets wet simply place it in the aerated mesh bag and allow it to dry naturally.
  • Available in seven different sizes - to ensure you find a size that perfectly fits your favourite shotgun mic.
  • Save valuable time while getting best quality.
  • Practical mesh bag included for easy storage and fast mounting.
  • Designed in Denmark by sound lovers, for sound lovers.

The Spacer Bubble shotgun microphone windshield is constructed of a noise-free mesh base, with a coarse foam inside and our specially designed rubber mount at the bottom.

The combination of the foam and the mesh provides the perfect conditions for recording indoors. And if you suddenly have to act fast and go outside, simply slip-on the long-haired fur and experience the optimal transparency within seconds.

When your recordings are wrapped, you can always keep track of your Spacer Bubble by leaving on the base on your boom or camera mic and store the slip-on fur in the included practical mesh storage bag. That way you’ll always be ready!

The materials used in The Spacer Bubble have been carefully selected and tested to ensure you are able to stay protected from the wind, whilst retaining as much of your microphones original frequency response as possible. If you're working in light to medium winds, we also have The Short-Haired Spacer Cover (sold separately) to allow you to further strike a balance between wind protection and frequency transparency.

Specifications

Schoeps CMIT 5U

Frequency range 40 Hz - 20 kHz
Sensitivity 17 mV/Pa
Equivalent noise level (A-weighted) 14 dB-A
Equivalent noise level (CCIR) 24 dB
Maximum sound pressure level at 0.5% THD 132 dB-SPL
Powering voltage 48 V
Current consumption 4.4 mA
Maximum output voltage 1.3 V
Impedance 50 Ω
Minimum recommended load impedance 600 Ω
Length 251 mm
Diameter 21 mm
Weight 89 g

Delivery Services

At Pinknoise Systems we like to offer our customers a wide choice of delivery options for their orders, and our prices are affordable and competitive. We also use only the best, most reliable couriers and delivery services to get your equipment where it needs to be - quickly and securely. Please find an outline of our services, prices and timescales below.

Delivery Times

Delivery times are based on when the package(s) leaves our premises. Sometimes, due to stock restrictions or a non-completed order, delivery may take longer as there is a delay with couriers, which is unfortunately out of our hands. If your order is urgent, or details change, please do let us know.
For full details, fees, and time schedules, please see our Delivery Information page.

Returns & Refunds

New items: You can return goods you have ordered from us for any reason, at any time within 30 working days of receipt (14 to initiate the process), for a full refund or for an exchange for a different product from our range. Items must be packed suitably and insured for full loss in the event of a delivery problem. Pinknoise Systems will not be responsible for lost or damaged return goods. Lost or damaged goods may affect the level of refund you receive. For full details of our returns policy, please click here.

Be the first to Write a Review for this item!

£1,890.00 £2,080.20
Saving Of:  £190.20 (9%)
(£1,575.00 Exc. VAT)
+

Availability:  

1 in stock now  

1 in stock now

Delivery hours
UK ORDERS: Order soon for delivery on using our express service

Model:  PN-BNDL-CMIT5U-SB
Manufacturer:  Schoeps

Schoeps
Contact us for advice

Need advice? Give us a call

(+44) 01453
825 802

International Delivery

International delivery

We ship across Europe and around the world and have a multitude of shipping options available to our international customers during the checkout, including express delivery for urgent orders.

NEXT DAY DELIVERY

We have a next day shipping option available for the UK with our DPD courier service, which features delivery alerts, personal delivery preferences and driver tracking with the DPD mobile app.

FINANCE AVAILABLE

Spread the cost to maximise your capital. Just call our helpful sales team on 01453 825 802, from 9.00am - 5.00pm, to discuss these options and find out what's available to you.

We accept Klarna, PayPal, Maestro, Visa, Mastercard & American Express

Schoeps CMIT5U w/ Bubblebee Spacer Bubble (M) Bundle

£1,890.00
× Site Currency
£0.00